Specifications
Equipped With
SPECIFICATIONS:
PUNCHING CAPACITY:
Nominal Tonnage 85
Punch Diameter thru thickness 1-1/16" thru 1"
Depth of Throat 7"
ANGLE SHEAR:
Angle at 90 deg 6" x 6", Angle at 45 deg 4" x 4"
FLAT BAR SHEAR STATION: 14" length
Capacity 1" x 12", 1/2" x 14"
Material Back Gage and Mechanical Sheet Hold-Down ROD SHEAR:
Round 1" Squares 1"
RECTANGULAR NOTCHER (COPER) CAPACITY: 3" wide x 5" deep x 1/2"
thickness
EQUIPPED WITH
Punch, Plate Shear, Rectangle Notcher, Rod Shear, Angle Shear
Anti-Repeat Electric Foot Switch to actuate Punch End and Shear
End.
Adjustable Stroke Controls.
Adjustable Stripper
1-Offset Die Holder
1-Notcher Table. 1-Shear Table.
Point of Operation Safety Guards at each cutting station.
Fork Lift Accommodations.
MOTOR DRIVE: Wired 230 volts, 3-phase
Hydraulic Pump 5 HP, 208-230/460 volts
CONTROLS: Wired Low Voltage
Located on Punch End & Rectangle Notcher End Emergency Stop
Button.
Located on Magnetic Control Box: Start / Stop Buttons. Run /
Jog Switch.
Dimensions: 60" LR x 30" FB x 77" Ht Approximate weight 4,200 lbs.
